Short articles

Installing a Bathroom Vanity and Countertop

The installation of a new bathroom vanity and countertop can transform an outdated bathroom into a contemporary one. Installing a мойка высокого давления vanity and countertop is simple to do and can be purchased from any home improvement store for less than $500.

Remove the old Vanity and Countertop

First turn off усилители мощности the water supplies under the vanity. Next авто усилители disconnect the supply lines at the valves. Then disconnect the drain pipe at the trap (the j-shaped section underneath the vanity). Next remove the corner screws that are securing the top of the old vanity to the countertop. The countertop should then be able to be lifted off of the old vanity.

After the countertop has been separated from the vanity, remove the faucet hardware if you plan on reusing the existing faucet. Make sure, however, when purchasing your new vanity countertop that it will support the faucet configuration (one hole or three holes – and the number of inches between the holes – center to center).

After the countertop and faucet have been removed from the work area, unscrew the back and/or side screws that hold the vanity to the wall(s). Then remove the vanity from the bathroom.

Installing the new Vanity and Countertop

Slide the new
vanity into the location where the previous vanity resided. Note: you will probably need to remove/cut away a portion of the back of the new vanity to allow the supply lines and drainage pipe to slide through. A jig saw works fine for this effort. Just make a couple of pilot holes with a drill and then use the jig saw to cut out the appropriate area.

Once the vanity is in position, you will need to активная акустика square it up with the back or side walls and make sure it sits level. If there are imperfections in наушники с микрофоном the walls when attempting to square it up (e.g. the walls are not straight), you can either scribe the vanity or use a small piece of trim to hide any imperfections. Scribing involves using a compass and cutting/shaving away a strip of the vanity edge such that the entire length of the cabinet edge sits evenly against the wall.

In order to level the vanity, shims may be necessary to temporarily hold the vanity in place. Make sure the vanity is level back to front and side to side. Then, using screws fasten усилитель the vanity to the walls. Make sure the screws are securely fastened to studs behind the sheetrock.

Once the vanity has been secured, it is now time to tackle the new countertop.

It is best to mount the faucet assembly to the countertop before placing the countertop onto the vanity. Once the faucet/supply lines and drain pipe have been installed to the countertop you are ready to place the countertop onto the авто акустика vanity. However, it is best to lay a bead of Liquid Nails (caulk adhesive) along the top of the vanity first. This will help to ensure that the countertop remains securely fastened to the vanity. In some cases, this may be all that is necessary or desired for securing the countertop to the vanity.

Place the countertop on top of the vanity making sure it sits square. Use screws to secure the vanity to the countertop. Usually there are corner blocks on the vanity to secure the screws to the countertop. Make sure, however, that you детские компьютеры use screws that will not penetrate through the top of the vanity.

Finally connect the supply line feeds (dangling down from the faucet) to the copper supply lines. Then connect the drain pipe of the bowl/sink to the J-Trap drainage pipe.

Turn on the hot/cold water supply line valves and you are done.

Me_Donovan@comcast.net
http://www.homeadditionplus.com
http://www.homeaddition.blogspot.com

Over the past 20+ years Mr. Donovan has фены для волос been involved with building homes and additions to homes. мультимедиа проектор His projects have included: building a vacation home, building additions and garages on to existing homes, and finishing unfinished homes. Mr. Donovan’s formal education and profession have been as an Electrical Engineer and Marketing Manager.

The Truth Behind Finance with Bad Credit

Bad Credit Personal Loans

Bad credit personal loans are specially designed for those who are not able to apply to regular loans due to the presence of stains in their credit report. It can be used for many purposes like debt consolidation, home improvements, as a business loan, for buying a new car or going on vacations; In fact, for any personal purpose you may think of. And, besides, if paid in time it will also help to improve your credit score and history.

Secured or Unsecured

A secured bad credit personal loan is the wisest option. Any asset of certain value, such as an automobile or a house can be used as collateral which greatly reduces the risk involved for the lender and contributes to making проектор nec it easier for the applicant to get approved while at the same time reducing the interest rate the borrower will have to pay. Bear in mind

This entry was posted on Thursday, April 30th, 2009 at 10:09 am and is filed under Video, images, resources. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.